Strutconfigurator
Free tool · cable fill

Cable tray fill calculator

Choose the containment and the cables that go in. The tool calculates the fill ratio, shows whether you stay within the rule of thumb and warns when power and data share a run without a divider.

Short answer

Fill ratio is the sum of the cross-sections of all cables divided by the cross-section of the containment (width × depth). A widely used rule of thumb is no more than 40% at installation, leaving room for expansion and heat; above 60% the tray is over-filled. Segregate power and data with a divider. Indicative.

Fill ratio
0%
OK

Rule of thumb, indicative: up to 40% fine, up to 60% full, above that over-filled. Diameters are typical values.

Which cable diameters does the tool use?

The same values as the configurator. They are typical, but every cable manufacturer gives its own diameter; use it if you have it.

CableTypeDiameter (mm)
Cat6A U/FTPdata7.5
Cat6A S/FTPdata8.0
OM4 patchfibre2.0
OM4 trunk MPO-12fibre6.0
OS2 trunk MPO-12fibre6.0
3G2.5power10.5
5G6power16.0
5G16power22.0

Frequently asked questions

How big should a cable tray be?

Big enough that the cables fill about 40% of the cross-section at installation (rule of thumb). Work it out with this tool and leave room for expansion.

Which cable tray do I need?

Choose the width on the cables plus room to expand, the depth on the cable diameter and the type on the environment: basket for data, tray for protection, ladder for heavy power.

Why does the tool use the full cross-section?

Because the usable cross-section differs per manufacturer. Some publish a usable cross-section; use it if you have it. The full cross-section keeps the rule of thumb easy to compare.

Can power and data share a tray?

Only with a divider or sufficient separation, following the applicable standards. The tool warns when that is not the case.

Next step

See your own range in 3D.

In 30 minutes we show how your installers configure, what arrives on your side and what the client version on your range involves.

Manufacturer or wholesaler

Book a demo with Ismail

You see the configurator in your own brand and we discuss your range, systems and markets.

Reply from Ismail within one working day

Installer

Configure for free

A trapeze, frame or tray with cables in a few minutes, with a bill of materials and drawing.

Enquiry goes to a supplier · reply within one working day