# Roof supports: strut on flat roofs

URL: https://strutconfigurator-site.pages.dev/en/roof-supports/

On a flat roof you want to keep the membrane intact. Roof support blocks carry strut channel, containment, pipes and units by their own weight, with no penetrations. In the configurator you set height and length and put containment or pipes on top.

> A roof support block is a rubber or plastic base, usually 200 × 200 mm, with a strut channel on top. It carries cable routes, pipes, HVAC units and panels on a flat roof by gravity, without penetrating the roof membrane. You set the height and channel length; the load spreads over the roof.

## What are roof supports used for?

For anything that has to sit on a flat roof without penetrating it: cable routes to solar panels, pipework from cooling plant, condensers and air handling units, and walkways. An H-frame on roof blocks lifts a route clear of the roof so water drains freely.

## What should you watch?

A roof block presses on the membrane and the insulation below. The compressive strength of the roof build-up and the weight per block set how many blocks you need. Use a protection layer under the block if the membrane manufacturer requires it, and allow for wind load on tall items. The configurator calculates indicatively; a structural engineer or the roof manufacturer confirms.

- Block about 200 × 200 mm, rubber or plastic
- Channel 41×41 or 41×21, HDG outdoors
- Height adjustable with threaded rod or an upright
- Block spacing according to load and channel

## Which finish for outdoors?

Hot-dip galvanised (HDG) is the outdoor standard. In salt-laden or aggressive environments choose stainless steel. Pre-galvanised material is meant for dry indoor areas and corrodes faster outdoors.

## Frequently asked questions

**Do you have to penetrate a flat roof for a cable route?**

Not with roof supports: they sit loose on the roof and carry the load by gravity. The membrane stays watertight.

**How much does a roof support block weigh?**

That varies by manufacturer and type. Ask your supplier for the data; the client version of the configurator uses it.

**Can an HVAC unit stand on roof supports?**

Yes, on a strut frame on roof blocks. Check weight, vibration and wind load with the unit manufacturer.

## Configure it yourself

Free, in 3D, with bill of materials, cutting list and drawing: https://strutconfigurator-app.pages.dev/?lang=en&systeem=dakvoet

---

Source: https://strutconfigurator-site.pages.dev/en/roof-supports/ · Last updated: 2026-11-19 · Loads are indicative; the manufacturer confirms.
Strutconfigurator is part of NEXTRIQ (Rotterdam).
