# Cable tray supports: tray and supports in one go

URL: https://strutconfigurator-site.pages.dev/en/cable-tray-supports/

A cable tray is only finished once it is supported. Which support, at what spacing, from which soffit? The configurator puts tray, supports and cables into one bill of materials.

> Cable tray is supported on trapeze brackets from threaded rod, on cantilever arms along a wall or on a centre hanger. Support spacing is usually between 1.2 and 1.5 m (rule of thumb); the tray manufacturer gives the permitted span for your tray and load. Also place a support close to every bend and coupler.

## How do you hang cable tray from the soffit?

From a concrete soffit with a ceiling anchor and threaded rod, from steelwork with a beam clamp, and above a suspended ceiling from the structure above, never from the ceiling grid itself. One tray often needs only a centre hanger or a narrow trapeze; several trays above each other become a multi-tier trapeze.

## What sizes of cable tray are there?

Choose the width on the cables that go in, with room for expansion, and the depth on the cable diameter. Lengths are usually 3 m.

| Property | Common |
|---|---|
| Width | 50, 75, 100, 150, 200, 300, 400, 500, 600 mm (UK also 225, 450, 750, 900) |
| Depth | 35, 60 or 100 mm |
| Length | 3,000 mm (also 2,000 and 6,000) |
| Material thickness | 0.6 to 1.5 mm |
| Type | perforated, solid or click-fit |

*Source: catalogues from three manufacturers (brand-independent standard catalogue, 19/11/2026).*

## How full can a cable tray be?

A widely used rule of thumb is no more than 40% fill at installation, leaving room for expansion and heat dissipation; above 60% it gets tight. Use the cable fill tool to compare the cross-section of your cables with the usable cross-section of the tray. Segregate power and data with a divider or separate trays.

## Which fittings belong with it?

45° and 90° bends, inside and outside risers, tees, reducers, couplers, dividers and covers. The configurator counts them per route, so the bill of materials includes fittings and the hold-down clamps on the beam.

## Frequently asked questions

**How far can you span a cable tray?**

Usually 1.2 to 1.5 m between supports as a rule of thumb. The tray manufacturer gives the permitted span per tray and load; follow it.

**Can you hang cable tray from a suspended ceiling?**

No. Hang it from the structure above with threaded rod and an anchor or beam clamp. Ceiling grids are not designed for it.

**What are the types of cable tray support?**

Trapeze brackets on threaded rod, cantilever arms on walls or channel, centre hangers, floor-standing H-frames, wall brackets and roof supports. The configurator covers all of them.

**How do you fix cable tray to a trapeze?**

With a hold-down clamp on the beam, so the tray cannot shift. The configurator counts the clamps.

## Configure it yourself

Free, in 3D, with bill of materials, cutting list and drawing: https://strutconfigurator-app.pages.dev/?lang=en&systeem=goot

---

Source: https://strutconfigurator-site.pages.dev/en/cable-tray-supports/ · Last updated: 2026-11-19 · Loads are indicative; the manufacturer confirms.
Strutconfigurator is part of NEXTRIQ (Rotterdam).
